playunderwaterhockey — Glove

MakerWorld description, captured October 30, 2026.
Source and latest instructions: https://makerworld.com/en/models/3391044-underwater-hockey-glove#profileId-3859519

Glove Gems for making an Underwater Hockey Glove.

I made this to fit my hand perfectly and might need to be resized for you. I have had a few other guys wear it and it fit fine. I'm probably a L or XL in HydroUWH.com sizes

This model uses TPU, a very durable and flexible 3D printed filament. A single roll should make you about 15 gloves and costs about $20.

Additional Parts

• Cut-Proof Gloves (https://amzn.to/4yvZY6Y) $8 for 4. Larger packs of them make them cheaper ~$.50. These are the same gloves that HydroUWH.com uses

• Cyanoacrylate Glue (https://link.amazon/B03mKDMZK) $15. After testing 5x glues for UWH purposes this type of glue is the clear winner. Careful though, its gnarly stuff.

• Latex gloves (https://amzn.to/47yLtDC) $10 to protect my hands from the glue when I put the glove on.

• Two Q tips (https://amzn.to/3VuZGyH) $3 for spreading the glue. Use one to hold the pad in place and the other to spread the glue.

• A disposable pad (paper or cardboard) to place the gems and Q tips on while gluing.

Directions

• Glue in a ventilated area and/or with a mask.

• Put latex gloves on both hands.

• Apply glue on one finger section at a time.

• Apply glue thinly and evenly on the whole gluing surface.

• Press each piece firmly into the glove for 10 seconds as the glue sets. You will feel the glue get warm as it sets.

For best results, make sure the glove is smooth and has no wrinkles as you place the pads on it.

Label Meanings

T: Thumb

PO: Pointer Finger

M: Middle Finger

R: Ring Finger

PI: Pinky Finter

PI0: Pad for on the side of the hand by the pinky

H: back of the hand

1, 2, 3: numbering that indicates what joint the pad should be placed on.

Early stages testing. Varying the walls and infill might help with durability.

The grip of the thumb on the back of the stick is a little slippery because it doesnt have the regular silicone over it. To fix this, you could apply silicone to this spot.

By downloading this model you agree that you make and use this at your own risk.
